Electrical Engineer

  • Contract

Job Description

Position: Electrical Engineer 2

Location: Redmond, WA

Duration: 12-18 Months

 

Job Description:

Develop, design, and implement electrical solutions for consumer electronic products including but not limited to schematic capture, part selection, PCB layout, analysis and validation of prototype systems that meet the goals of the product while managing constraints in space, time, cost, performance, power, signal integrity, timing margins, and manufacturing.  Direct and coordinate electrical engineering services as required.  Collaborate with design, firmware, compliance, mechanical engineering, and many other engineering and design disciplines to optimize the overall system of the product.  Develop project documentation including specifications, schematic diagrams, PCB layouts, schedules and presentations to fully capture and communicate the electrical design to achieve the projects goals.

Qualification:

  • BS, MS or PhD in EE required and/or 10-15 years of relevant experience.
  • Hands-on experience in design, development and launch of high-volume consumer electronic product is a must.
  • Requires strong design skills, managing through ambiguity, and technical problem-solving skills.
  • Excellent interpersonal, influencing, leadership, verbal and written communication skills required.
  • Experience using Cadence DE-HDL schematic capture and Allegro layout design tools.
  • Excellent project management, communication and teamwork skills required.
  • Demonstrated ownership of multiple sub-systems and/or a complete simple product (Simple = Mouse or iPod shuffle) and/or experience launching multiple moderately complex to complex consumer electronic products: Moderately Complex = Smart TV/DVD, Complex = smart phone/Xbox.

Additional Information:

  • Familiar with EE test equipment
  • Strong knowledge of power management a. Power Supply design – SMPS, Linear, Load switch, key external components selection b. Key parameter of power measurements c. PI design, check, validation and trade-off
  • Strong knowledge of High-speed interface (PCIe, USB3, DP, HDMI) a. SI principle and PCB/FPC implementation practice b. Hands-on test expertise c. Protocol familiarity a plus
  • Strong system debug and troubleshooting experience
  • Hands-on experience with EDA tools 6. RF design experience a plus

Additional Information

All your information will be kept confidential according to EEO guidelines.

By clicking the link above or any third-party link within this posting, you are leaving this site and going to a third-party website where the third-party website's terms and privacy policy apply